top of page
globalstar-logo500.png

6C.1.K2

Industrial Polyurethane Topcoat

Suggested Uses

As a gloss topcoat over properly prepared primed or sealed substrates and sanded stable coatings, including: Hot and Cold roll steel, Galvanized Steel, Aluminum, fiberglass, plastics and wood where:
Good gloss and color retention are desired.
Outstanding adhesion and flexibility is required.
Excellent durability and chemical resistance.
Excellent performance when using air-assist airless, pressure pot, cup gun and Roller or brush application.

Components

  • 6C.1. K2 Base

  • 0G.013 Medium Polyurethane Reducer

  • 0G.030 Slow Polyurethane Reducer

  • 0A.014 Hardener

Mixing Ratio
Mix:  Mix three (3) parts base color to one (1) part 0A.014 hardener.
        Reduce with Selected Reducer 0-5%

 

Application
Apply:         Two wet coats, allow 10-30 minutes flash between coats, or one cross coat.

Spray Gun:   HVLP Gravity Feed – 1.2 – 1.4mm tip and needle
                    Pressure Pot HVLP – 1.0 – 1.1mm tip and needle
                    Air Assist Airless - 1.0 – 1.1mm tip and needle
                    Conventional – 1.2 – 1.4mm tip and needle

 

Film Build:    40-50 microns – when applied as directed.

bottom of page