top of page
globalstar-logo500.png

2I.3.70121

Epoxy Primer

Suggested Uses

As a non-sand or sand-able primer.
Over any of the above mentioned properly prepared substrates where:

  • High level of corrosion resistance is needed.

  • Excellent adhesion is needed.

  • High productivity is required.

  • VOC restrictions are present.

  • Excellent performance when applied with airless, air-assist airless

      pressure pot, cup gun.

 

Components

  • 2I.3.70121 Base

  • 0G.006 Epoxy Reducer

  • 0B.150 Quick Epoxy Hardener

  • *0B.V50* *Epoxy Vinyl Hardener* (For extended open time before topcoat)

Mixing Ratio
Mix:             Four (4) parts 2I.3.70121 Epoxy Base to one (1) part 0B.150 Epoxy Hardener.

                   Reduce 0%-15% with selected reducer.
                   *Option, 0B.V50 Hardener can be used at the same mixing ratio to extend the recoat

                   open time on this product to one month.

Application
Apply:         One to two medium wet coats, allow 10-20 minutes flash between coats.
                   Or Apply one medium light coat followed by a medium cross coat.

Spray Gun:   HVLP Gravity Feed – 1.4 – 1.6mm tip and needle
                     Pressure Pot HVLP – 1.0 – 1.2mm tip and needle
                     Air Assist Airless - 1.0 – 1.2mm tip and needle
                     Conventional – 1.5 – 1.8mm tip and needle
                     Airless - 310 – 610 – 313 – 613 nozzle
                     Brush or Roller for small areas.

 

Film

Film Build:    50-60 microns – (2.0 – 2.5 mils.)

bottom of page