top of page
globalstar-logo500.png

6H.3.K2

Matt MS Acrylic Polyurethane Topcoat

3G.1K1

Suggested Uses

As a high performance topcoat over properly prepared primed or sealed substrates and sanded stable coatings, including: Hot and Cold roll steel, Galvanized Steel, Aluminum, fiberglass, plastics and wood where:

  • Outstanding color retention are desired.

  • Outstanding adhesion and flexibility is required.

  • Excellent durability and chemical resistance.

  • Excellent performance when using air-assist airless, pressure pot, cup gun and Roller or brush application.

Components

  • 6H.3. K1 Base

  • 0G.013 Medium Polyurethane Reducer

  • 0G.030 Slow Polyurethane Reducer

  • 0A.014 Hardener

Mixing Ratio
Mix:             Mix four (4) parts base color to one (1) part 0A.014 hardener.
                   Reduce with Selected Reducer 15%

 

Application
Apply:         Two medium wet coats, allow 10-20 minutes flash between coats, or one cross coat.

Spray Gun:   HVLP Gravity Feed – 1.4 – 1.6mm tip and needle
                    Pressure Pot HVLP – 1.0 – 1.1mm tip and needle
                    Air Assist Airless - 1.0 – 1.1mm tip and needle
                    Conventional – 1.4 – 1.7mm tip and needle
                    Can be brushed on small areas.

Film

Film Build:    40-50 microns – when applied as directed.

bottom of page