top of page
globalstar-logo500.png

6B.1.K1

High Gloss DTM Industrial Polyurethane

Suggested UsesAs a high performance topcoat over suitable primers or over properly prepared substrates, including: Hot and Cold roll steel, Galvanized Steel, Aluminum, fiberglass, plastics and wood where:

  • Outstanding Gloss and color retention are desired.

  • Outstanding adhesion and flexibility is required.

  • Excellent DOI and leveling is required.

  • Excellent performance when using air-assist airless, pressure pot, cup gun.

  • Can be applied in small areas with roller or brush.

Components

  • 6B.1. K1 Base

  • 0G.013 Polyurethane Reducer Standard

  • 0G.030 Polyurethane Reducer Slow

  • 0A.014 Hardener

Mixing Ratio
Mix:  Mix three (3) parts base color to one (1) part OA.014 hardener.
        Reduce up to 20% with Selected Reducer.

Application
Apply:         Two medium wet coats, allow 10-20 minutes flash between coats.

Spray Gun:   HVLP Gravity Feed – 1.4 – 1.6mm tip and needle
                    Pressure Pot HVLP – 1.0 – 1.1mm tip and needle
                    Air Assist Airless - 1.0 – 1.1mm tip and needle
                    Conventional – 1.4 – 1.7mm tip and needle
                    Airless Not recommended.

 

Film Build:    60-90 microns – (2.4 – 3.6 mils.) when applied.

bottom of page
{ "@context" : "http://schema.org", "@type" : "Organization", "name" : "Lusid Technologies", "url" : "http://lusidtechnologies.com", "sameAs" : [ "http://www.facebook.com/your-profile", "https://www.instagram.com/lusid_technologies/", "https://www.facebook.com/lusid.biz/", "https://twitter.com/lusidtech/", "https://www.linkedin.com/company/lusidtechnologies/"] }